District of Columbia HVAC License: Requirements, Exam and How to Apply, District of Columbia HVAC License, District Of Columbia, Journeyman Refrigeration & Air Conditioning Mechanic, Master Refrigeration & Air Conditioning Mechanic, Retaking the exam, District of Columbia Board of Industrial Trades, how to get a District of Columbia HVAC License, District of Columbia HVAC License requirements, District of Columbia HVAC License exam, District Of Columbia licensing board, District Of Columbia contractor license, license application steps, Journeyman exam

Home Licenses HVAC License District of Columbia

HVAC License · Journeyman & Master

District of Columbia HVAC License: Requirements, Exam and How to Apply

In DC, HVAC work falls under the Refrigeration and Air Conditioning Mechanic license, offered at Journeyman and Master levels. This guide covers what each one lets you do, how you qualify and what the PSI exams look like.

Last updated October 27, 2026 from District of Columbia Board of Industrial Trades requirements

Exam time

2–3.5 hrs

2 hrs for Journeyman, 3.5 hrs for Master

Time to get license

Varies

5 yrs of experience, an exam, or a mix the Board approves

Continuing ed

Not required

Applies to both Journeyman and Master

Do you need a District of Columbia HVAC license?

Yes. The Board of Industrial Trades licenses refrigeration and air conditioning work in the District. With a Journeyman license you can work on systems up to 25 compressor horsepower. With a Master license, system size doesn’t matter.

You need the license when

  • Putting in refrigeration or air conditioning systems
  • Maintenance, repair or replacement of refrigeration or air conditioning systems
  • Overseeing that work for someone else
  • Any system over 25 compressor horsepower or its equivalent in tons (needs a Master license)

Exceptions

  • We couldn’t confirm any exemptions, so check with the Board before you take a job
  • Each license carries the limits set out in §301 of DC’s rules

What happens if you work unlicensed

The sources we checked don’t give penalty amounts. Since the Board can deny or discipline licenses, hold off on any refrigeration or air conditioning work in DC until you have your license in hand.

How to get a District of Columbia HVAC license in 6 steps

  1. Choose your level Before you start
    Go with Journeyman if you’ll work on systems up to 25 compressor horsepower, or Master if you want no size limit.
  2. Gather your qualifications Before you apply
    Collect proof of 5 years of work on systems over 25 HP right before you apply. If you don’t have that, plan to qualify by exam or by a mix the Board approves.
  3. Get approved to test Before you test
    Open an account with the Board of Industrial Trades, then request the Board’s approval to take the exam.
  4. Book your exam with PSI Online or by phone
    Schedule at candidate.psiexams.com or by calling 855-557-0616. You’ll find test centers across the District.
  5. Pass the exam Exam day
    The Journeyman exam has 60 questions and a 2-hour limit. The Master exam has 80 questions and 3.5 hours. You can use references on both.
  6. Apply for the license Once you pass
    Once you’ve passed, you apply for the license itself online through the DC professional licensing site.

District of Columbia HVAC application checklist

Everything for your District of Columbia application on one page

  • Decide on Journeyman (up to 25 HP) or Master (any size)
  • Proof of 5 years’ experience or a passing qualifying exam
  • An account with the Board of Industrial Trades and exam pre-approval
  • Your PSI exam scheduled and passed
  • Your license application filed online

District of Columbia HVAC license classes

There are two levels of refrigeration and air conditioning license in DC. What separates them is how big a system you’re allowed to work on.

JRY Smaller systems

Journeyman Refrigeration & Air Conditioning Mechanic

This level lets you install, maintain, repair or replace refrigeration and air conditioning systems, or oversee that work, as long as the systems add up to no more than 25 compressor horsepower or the same in tons.

ExamJourneyman exam
LimitUp to 25 HP

MST Any size

Master Refrigeration & Air Conditioning Mechanic

Perform or supervise the installation, maintenance, repair or replacement of any refrigeration or air conditioning system and its parts, no matter how large.

ExamMaster exam
LimitNo size limit

Requirements for each District of Columbia HVAC class

You can qualify through experience, through an exam or through a mix the Board approves. Whichever route you take, you still have to pass the license exam for your level.

RequirementJourneymanMaster
Experience route5 years working on systems over 25 HP, just before you apply5 years working on systems over 25 HP, just before you apply
Exam routeA practical and theory exam covering systems over 25 HPA practical and theory exam covering systems over 25 HP
Mixed routeWhatever combination the Board acceptsWhatever combination the Board accepts
License exam60 questions, 2 hours80 questions, 3.5 hours
Systems you can work onUp to 25 HPAny size
Minimum ageNot statedNot stated

The District of Columbia HVAC exam

You can bring references into either DC refrigeration and air conditioning exam, and both test the same subjects. Expect the Master version to run longer and dig further in.

Format

Open book

Questions

60 or 80

Passing score

Not stated

Exam vendor

PSI

Scoring and content

  • Journeyman: 60 questions in 2 hours
  • Master: 80 questions in 3.5 hours
  • What’s covered: theory and types of systems, refrigerant and condensate piping, compressors, condensers, chillers, cooling towers, heat pumps, air distribution and ductwork, electrical controls, refrigerants, safety, and maintenance and repair
  • The 2012 International Mechanical Code and Modern Refrigeration and Air Conditioning are among the references
  • Your references must be bound, but you can tab and highlight them

Retaking the exam

  • We couldn’t confirm the retake rules
  • Call PSI at 855-557-0616 before you book again
  • The Board has to pre-approve you before you can schedule

Books and codes for this exam (open book)

The District of Columbia Journeyman and Master Refrigeration & Air Conditioning exams are open book. You can tab and highlight the references below and use them during the test, as long as they’re bound.

ReferenceEditionHow it’s used
International Mechanical Code (IMC)2012Allowed in exam
Modern Refrigeration and Air Conditioning22nd editionAllowed in exam

Prep for the District of Columbia HVAC exam

Our exam prep course, Total Prep and complete bundle for the District of Columbia HVAC exam. Prices are coming soon.

Books for this exam

Renewing your District of Columbia HVAC license

You don’t need continuing education to keep a Journeyman or Master Refrigeration and Air Conditioning license in DC. A license lasts up to 2 years and expires on September 30 of even-numbered years. Renewing costs $155, plus $50 if you’re late.

Renewal cycle

Up to 2 years

CE hours

Not required

Renewal fee

$155

Late penalty

$50

Licensed in another state?

You can’t transfer a Journeyman or Master Refrigeration and Air Conditioning license into DC from another state.

No reciprocity with other states

If you’re licensed elsewhere, you apply as a new applicant, meet DC’s experience or exam rules and pass the PSI exam.

City and county rules in District of Columbia

Because DC is one jurisdiction, the District runs both licensing and permitting. You won’t deal with a separate county level.

What the District licenses

  • Journeyman and Master Refrigeration and Air Conditioning licenses
  • Approval to sit for the exam, through the Board of Industrial Trades
  • Disciplining license holders

Local permits and inspections

  • The District itself issues mechanical permits and does inspections
  • There’s no extra city or county license

Who oversees HVAC mechanics in the District of Columbia

Licensing authority

District of Columbia Board of Industrial Trades

1-866-270-9817

dcra.dc.gov/professional-licensing

What the board does

  • Approves who can sit for the exam
  • Issues the Journeyman and Master Refrigeration and Air Conditioning licenses
  • Decides which mixes of experience and exams count
  • Takes disciplinary action against license holders

District of Columbia HVAC license: common questions

How is a DC Journeyman HVAC license different from a Master license?

With a Journeyman license you can work on refrigeration and air conditioning systems up to 25 compressor horsepower. A Master license has no size limit.

How do you qualify for a refrigeration and air conditioning license in DC?

You need 5 years of work on systems over 25 horsepower just before you apply, a passing score on a practical and theory exam, or a mix of the two that the Board accepts. On top of that, you pass the license exam for your level.

Can you use books on the DC HVAC license exam?

Yes, it’s open book. Your references must be bound, and you can tab and highlight them. Journeyman candidates get 60 questions in 2 hours, and Master candidates get 80 questions in 3.5 hours.

Who gives the HVAC license exams in DC?

PSI runs them. Once the Board approves you, book online at candidate.psiexams.com or call 855-557-0616.

Does DC accept an HVAC license from another state?

No. If you hold a Journeyman or Master Refrigeration and Air Conditioning license from another state, DC won’t accept it through reciprocity.

Do you need continuing education for a DC HVAC license?

No. There’s no continuing education requirement for these licenses in DC.

Where this information comes from

  1. DC Professional Licensing, Board of Industrial Trades
  2. PSI Exams, DC candidate scheduling
  3. DC Board of Industrial Trades, Refrigeration and Air Conditioning Mechanic rules (§301)
  4. DLCP Board of Industrial Trades, fee schedule
  5. PSI Washington D.C. Contractor/Trades Candidate Information Bulletin

Last updated October 27, 2026. Spot something out of date? Tell us.

Linden Prep is an independent exam prep and continuing education company. It is not affiliated with the District of Columbia Board of Industrial Trades.