Arizona Specialty Contractor License: Requirements, Exam and How to Apply, Arizona Specialty Contractor License, Arizona, Residential Drywall & Acoustical Systems, Commercial Drywall & Acoustical Systems, Dual Drywall & Acoustical Systems, Residential Insulation, Commercial Insulation, Dual Insulation, Retake policy, Arizona Registrar of Contractors, how to get a Arizona Specialty Contractor License, Arizona Specialty Contractor License requirements, Arizona Specialty Contractor License exam, Arizona licensing board, Arizona contractor license, Required

Home Licenses Specialty Contractor License Arizona

Specialty Contractor · Drywall & Insulation

Arizona Specialty Contractor License: Requirements, Exam and How to Apply

Arizona licenses drywall and acoustical systems work as R-10, C-10 and CR-10, and insulation work as R-40, C-40 and CR-40. Below you’ll see who needs each one, the experience and exams, the bond rules and how to apply through the Registrar of Contractors.

Last updated October 27, 2026 from Arizona Registrar of Contractors requirements

Exam time

75 min

PSI trade exam: 30 questions, open book

Time to get license

~2 yrs

Either 2 years’ experience or, where allowed, a passed trade exam

Continuing ed

Not required

You don’t need CE to renew

Do you need an Arizona specialty contractor license?

Yes, if you take contracts for insulation, acoustical systems or drywall work in Arizona. The Registrar of Contractors licenses each of these trades by classification, and yours sets whether you can work on commercial projects, homes or both.

You need the license when

  • You repair or install gypsum wallboard, movable partitions, or wallboard tape and texture
  • You put in non-load-bearing lightweight steel wall partitions or ceiling grid systems that hold drywall
  • You repair or install insulation, radiant barriers and insulation protecting materials included
  • You put in preformed architectural acoustical materials

Exceptions

  • Arizona law does exempt some work from licensing, but we couldn’t confirm which. Check with the Registrar of Contractors before you count on an exemption.
  • With a dual (CR) license you can do residential and commercial work, so one trade doesn’t need two licenses

Penalties for unlicensed work

The Registrar of Contractors can take enforcement action if you contract without the correct classification. We couldn’t confirm specific fines, so ask the Registrar about current penalties.

How to get an Arizona specialty contractor license in 6 steps

  1. Pick a classification Before you start
    Choose your trade (insulation or drywall) and your scope: residential (R), commercial (C) or dual (CR). That decision sets your bond and your exam.
  2. Set up your business Before you apply
    Create a legal entity to hold the license, and collect background check details for each person on the application.
  3. Finish the SRE Online only
    Unless you’re eligible for a waiver, take the Arizona Statutes and Rules Training Course and Exam through the Registrar of Contractors.
  4. Pass the trade exam through PSI 75 minutes
    Book the open-book exam (30 questions) through PSI or by phone at 855-744-0310, and score 70% to pass. It’s mandatory for C-40 and CR-40; everyone else can use 2 years’ experience in its place.
  5. Buy your surety bond Before you apply
    For commercial drywall, the bond ranges from $2,500 to $50,000 depending on the yearly volume you expect. A dual license adds the residential and commercial amounts together.
  6. Apply through the Registrar of Contractors
    Send the Registrar your application along with your bond, background checks, experience and exam results. The checklist is at roc.az.gov/get-a-license-checklist.

Arizona specialty contractor application checklist

Arizona’s application on one page

  • A legal business entity
  • The Statutes and Rules course and exam (SRE), done
  • A passing PSI trade exam score, or proof of 2 years’ experience where that’s allowed
  • A background check for each person on the application
  • A surety bond that fits your classification and volume

Arizona specialty contractor license classes

Both trades come in three versions: residential (R), commercial (C) and dual (CR), which covers residential and commercial. Choose based on the jobs you’ll bid.

R-10 Residential

Residential Drywall & Acoustical Systems

On residential projects: tape and texture, gypsum wallboard, movable partitions, drywall ceiling grids and non-load-bearing steel partitions.

ExamTrade exam or 2 yrs experience, plus SRE
LimitNot stated

C-10 Commercial

Commercial Drywall & Acoustical Systems

Covers the R-10 drywall and acoustical systems scope, but on commercial projects.

ExamTrade exam or 2 yrs experience, plus SRE
LimitBond based on annual volume

CR-10 Most flexible

Dual Drywall & Acoustical Systems

Includes everything in both the R-10 and the C-10.

ExamTrade exam or 2 yrs experience, plus SRE
LimitResidential + commercial bonds

R-40 Residential

Residential Insulation

Insulation work on homes. You can qualify with experience in place of the trade exam.

ExamTrade exam or 2 yrs experience
LimitNot stated

C-40 Commercial

Commercial Insulation

Commercial insulation work, covering radiant barriers, insulation protecting materials and preformed architectural acoustical materials.

ExamTrade exam + SRE + 2 yrs experience
LimitNot stated

CR-40 Most flexible

Dual Insulation

Insulation work in residential and commercial settings alike.

ExamTrade exam + SRE + 2 yrs experience
LimitNot stated

Requirements for each Arizona specialty contractor class

The trade exam is where these differ most. Drywall and R-40 applicants can qualify through experience or the exam, but C-40 and CR-40 applicants need both.

RequirementDrywall (R-10, C-10, CR-10)Insulation C-40 / CR-40Insulation R-40
Experience2 years, or a passed trade exam2 years2 years, or a passed trade exam
Trade examOptional if you have the experienceRequiredOptional if you have the experience
Statutes and Rules (SRE)Required, unless waivedRequired, unless waivedRequired, unless waived
Background checkEveryone on the applicationEveryone on the applicationEveryone on the application
Business entityRequiredRequiredRequired
Surety bondC-10: $2,500–$50,000, based on volumeNot statedNot stated
Continuing edNot requiredNot requiredNot required

The Arizona specialty contractor exam

You may have two tests: PSI’s insulation or drywall trade exam, and the SRE (Statutes and Rules Training Course and Exam) online. Books are allowed on the trade exams, so get used to looking answers up in your references.

Format

Open book, computer

Questions

30

Passing score

70%

Exam vendor

PSI

Scoring and content

  • Drywall: OSHA safety, veneer plaster, taping and finishing, drywall materials and installation, and ceilings and acoustical systems
  • Insulation: OSHA safety, vapor retarders, insulation theory, and batt and roll, blown or loose-fill, spray-on, rigid-board and reflective insulation
  • 75 minutes for 30 questions; 70% passes
  • Mark up your books ahead of time if you like; writing in them during the exam isn’t allowed
  • See the PSI Candidate Information Bulletin for the references you can bring

Retake policy

  • If you fail a PSI trade exam, wait 30 days before you retake it
  • After 3 attempts, you have to wait 90 days between tries
  • Every try costs the same $66 PSI fee, which stays valid for one year
  • Pass first, then send in your application

Books and codes for this exam (open book)

The Arizona Drywall and Acoustical Systems (R-10, C-10, CR-10) and Insulation (R-40, C-40, CR-40) trade exams are open book. You can annotate your books before the exam, but you can’t write in them during the test; the Statutes and Rules Training Course and Exam is taken online and has no book list.

ReferenceEditionHow it’s used
OSHA 1926 Construction Industry RegulationsNot statedAllowed in exam
The Gypsum Construction Handbook — Drywall and Acoustical Systems exams7th editionAllowed in exam
International Residential Code (IRC) — R-10 and CR-10 Drywall exams2018Allowed in exam
International Building Code (IBC) — C-10 and CR-10 Drywall exams2018Allowed in exam
Carpentry & Building Construction, Student Edition — Insulation exam2016Allowed in exam
Insulation Handbook (Bynum and Rubino) — Insulation exam2000Allowed in exam

The Insulation Handbook is out of print, so you may not be able to buy a copy.

Prep for the Arizona specialty contractor exam

Our exam prep course, Total Prep and complete bundle for the Arizona specialty contractor exam. Prices are coming soon.

Books for this exam

Renewing your Arizona specialty contractor license

You don’t need any continuing education to renew in Arizona. Each license lasts two years. Residential renewal costs $270 plus a $270 recovery fund assessment, commercial costs $480, and dual costs $380 plus $270.

Renewal cycle

2 years

CE hours

Not required

Renewal fee

$480–$650

Late penalty

Not stated

Licensed in another state?

Three states have reciprocity agreements with Arizona. We couldn’t confirm exactly what each agreement waives, so check with the Registrar of Contractors before applying.

California: reciprocity agreement

We couldn’t confirm the details. Ask the Registrar what you can skip.

Nevada: reciprocity agreement

We couldn’t confirm the details. Ask the Registrar what you can skip.

Utah: reciprocity agreement

We couldn’t confirm the details. Ask the Registrar what you can skip.

Every other state: no agreement

You apply as a new applicant and meet every experience and exam requirement.

City and county rules in Arizona

A Registrar of Contractors license is good anywhere in Arizona. Each job’s permits and inspections still go through the city or county.

State handles

  • Contractor licenses and their classifications
  • Trade exams (given by PSI)
  • The Statutes and Rules Training Course and Exam
  • Background check and bond rules

City and county handle

  • Building permits
  • Inspections
  • Local business licenses, if your area requires one

Who oversees specialty contractors in Arizona

Licensing authority

Arizona Registrar of Contractors

roc.az.gov

What the board does

  • Issues dual, commercial and residential contractor licenses
  • Defines each classification and its scope of work
  • Offers the Statutes and Rules Training Course and Exam
  • Sets the bond and background check rules

Arizona specialty contractor license: common questions

Do I need an Arizona contractor license to hang drywall?

Yes, if you’re contracting for it. Residential work takes an R-10, commercial work takes a C-10, and doing both takes a CR-10.

Can I get an Arizona drywall license without the trade exam?

Yes. As a drywall applicant, you can show 2 years of managerial or hands-on experience in place of the trade exam. The Statutes and Rules course and exam are still required unless you’re eligible for a waiver.

Arizona C-40 vs. CR-40 insulation license: what’s the difference?

A C-40 is limited to commercial insulation work, while a CR-40 covers residential and commercial. For either one, you need 2 years of experience, the SRE and the PSI exam.

Is the Arizona specialty contractor trade exam open book?

Yes. You can bring books to both the insulation and drywall exams, which give you 75 minutes for 30 questions with a 70% pass mark. Mark your books up ahead of time, since you can’t during the test.

What is the Arizona SRE for specialty contractors?

SRE is short for the Statutes and Rules Training Course and Exam. The Registrar of Contractors offers it online, and it took over from the old Statutes and Rules exam.

How much is the bond for an Arizona C-10 license?

That depends on the yearly volume you expect. It starts at $2,500 for under $150,000 and goes up to $50,000 for work over $10 million. For a dual license, you add the residential and commercial amounts.

Do Arizona specialty contractors need continuing education?

No. You can renew in Arizona without any continuing education.

Does Arizona accept specialty contractor licenses from other states?

Only through its reciprocity agreements with Utah, Nevada and California. Ask the Registrar of Contractors what your license lets you skip.

Where this information comes from

  1. Arizona Registrar of Contractors, Get a License checklist
  2. PSI, Arizona contractor exam scheduling
  3. PSI, Arizona Contractor Candidate Information Bulletin
  4. Arizona Registrar of Contractors, Statutes and Rules Training Course and Exam (SRE)
  5. Arizona Registrar of Contractors, License and Renewal Fees

Last updated October 27, 2026. Spot something out of date? Tell us.

Linden Prep is an independent exam prep and continuing education company. It is not affiliated with the Arizona Registrar of Contractors.